Switching Off The Mower Mechanism; Emptying The Grass Catcher; Mowing Interval; Mowing High Grass - AL-KO solo T22-110.0 HDH-A V2 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 92
GB
1. Press the "Reverse mowing" button (02/6)
and, within 5 seconds, press the pedal for re-
verse driving (04/1).
WARNING! There is an accident risk
when reverse mowing! Pay attention to the area
behind you when mowing in reverse! Only mow
in reverse when it is necessary to do so!
7.5.5.3

Switching off the mower mechanism

WARNING! Danger due to spinning
blades! When the cutting blades are still spin-
ning, they can cause laceration injuries to hands
and feet! As a result, keep your hands and feet
away from the cutters!
1. Disengage the mower mechanism using the
toggle switch (02/5, position "0").
The mower mechanism can be switched off when
the tractor is at a standstill and when it is being
driven.
WARNING! Risk of injury due to objects
being thrown out! When crossing areas of grav-
el and crushed stone, objects can be drawn into
the running mower mechanism and then thrown
out.
Always switch off the mower mechanism if
you are driving over surfaces other than
lawns.
7.5.5.4

Emptying the grass catcher

NOTE An audible signal sounds when the
grass catcher is full. The catcher should be emp-
tied now if not before.
Depending on the equipment variant, your lawn
tractor has electrically operated grass catcher
emptying or a manually operated grass catcher
with operating lever.
The following applies to all catcher types:
The grass catcher can be emptied from the
operator's seat.
The engine cuts out if the grass catcher is lift-
ed up or disconnected when the mower
mechanism is switched on.
The mower mechanism cannot be switched
on unless the grass catcher is engaged cor-
rectly.
Emptying the electrically operated grass
catcher
1. For emptying, operate the toggle switch
(07/1) on the left of the operator's seat.
40
2. To close the grass catcher, operate the tog-
gle switch again.
Emptying the grass catcher with operating
lever
1. Pull the operating lever out of the grass
catcher (17/a).
2. Push the lever in the driving direction so the
grass catcher opens (17/b).
3. Move the grass catcher backwards with the
lever until the catcher engages.
7.5.5.5
Mulching
For optimum mulching results, the grass should
be mowed on a regular basis (approx. 1 or 2
times per week). When doing so, cut 1/3 of the
grass height (e.g. if grass height is 6 cm, mow
2 cm). This will ensure that the mown grass will
be properly intermixed in the remaining grass.
7.5.5.6

Mowing interval

Please take into account that grass grows differ-
ently at different times. We recommend using a
shorter interval between mowing during early
spring. You can increase the mowing intervals as
the growth rate of the grass begins to decline
during the course of the year.
If you are unable to mow the grass for an extend-
ed period, you should initially select a higher cut-
ting height setting, then re-mow two days later
with a lower cutting height setting.
7.5.5.7

Mowing high grass

Mow with a higher cutting height adjustment
when the grass is longer than normal or when it
is wet. Then re-mow the grass with a lower, nor-
mal setting.
7.5.5.8

Cutting blade maintenance

Make sure that the cutting blade remains sharp
for the entire mowing season to avoid shredding
or tearing the blades of grass. Shredded grass
blades turn brown on the edges. This reduces
their growth and leaves the lawn prone to diseas-
es.
Check the cutting blade for sharpness and
signs of wear or damage after each use! If
necessary please contact a service work-
shop.
If replacement is required, only use original
manufacturer replacement blades.
Operating the tractor
493516_a
Tabla de contenido
loading

Tabla de contenido