Attaching The Weight Tower To The Movement Frame - Precor Discovery Selectorized Serie Manual Del Propietário

Attaching the Weight Tower to the
Movement Frame
Note: Do not tighten fasteners until instructed to do so.
Have your assistant hold the movement frame in an upright, balanced position
while you complete the following procedure.
To attach the weight tower to the movement frame:
1. Remove the two bolts, two lock washers, and two flat washers from the
cross support using a ⁵ ₁₆-inch hex bit. Set them aside.
Figure 2: Cross support attachment
2. Locate the point where the base support attaches to the movement frame.
Using a ⁵ ₁₆-inch hex bit, remove the two bolts, two lock washers, and two
flat washers installed there and set them aside.
Note: The nuts are already attached to the transition plate.
Leg Press Assembly Guide: Assembling the Equipment
3. Attach the base support to the movement frame using the bolts and
washers removed previously. Partially tighten the fasteners.
Figure 3: Base support attachment
4. Slide the cross support onto the transitional plate on the movement frame,
and attach the cross support using the fasteners previously removed.
Figure 4: Slide cross support onto transitional plate
4