Precor Discovery Selectorized Serie Manual Del Propietário página 60

3. Using a ³ ₄-inch socket wrench and a ³ ₄-inch open-end wrench, remove the
nut and cable retainer on the second pulley.
Figure 15: Cable retainer removal
4. Thread the cable over the pulley and replace the cable retainer, making
sure that the cable is positioned in the pulley groove and under the cable
retainer. Using a ³ ₄-inch socket wrench and a ³ ₄-inch open-end wrench,
tighten the nut to 500 in-lb (56 N-m) of torque.
Leg Press Assembly Guide: Routing the Cable Assembly
5. Thread the cable down through the opening under the second pulley, as
shown in the following figure.
Figure 16: Cable route down through weight tower frame
6. Guide the cable down to the weight stack. Remove and discard the
temporary bolt threaded into the selector stem on the weight stack.
7. Insert the cable bolt into the stem and thread it at least 7 threads (turns).
The distance from the underside of the bolt head to the top of the weight
selector stem should be no more than 1¹ ₄-inch (32 mm).
Important: Make sure at least seven (7) threads on the cable bolt extend into
the selector stem.
Figure 17: Cable attachment into weight stack
10