Installing The Infant Carrier Without The Base Using A Lap And Shoulder Belt - CYBEX Aton 2 Manual Del Propietário

Installing the Infant Carrier without the Base using a Lap and Shoulder Belt

1. Position Infant Carrier on a rear vehicle seat, with the foot
end rmly against the back of the vehicle seat.
2. Route just the lap belt portion under both Belt Guides. BUCKLE THE BELT.
3. Lift shoulder belt over handle and around Carrier. Slide
shoulder belt into the BLUE
4. LOCK your vehicle lap shoulder belt. Refer to your vehicle Owner's
Manual for how your vehicle lap and shoulder belt locks.
In many vehicles, you can switch the shoulder belt retractor into locking
mode by pulling the shoulder belt out all the way. In some vehicles the
buckle locks. Check the vehicle Owner's Manual
system locks.
To check if the vehicle belt is locked, after you install the infant carrier,
pull up rmly on the lap belt between the Belt Guides. The belt should
remain tight if the vehicle system is locked.
NEVER install this child restraint using a non-locking vehicle lap shoulder
belt. A locking clip MUST BE used with a vehicle belt that DOES NOT
LOCK. Call the Regal Lager Customer Care Department at
1.800.593.5522 to obtain a locking clip.
5. Push Infant Carrier rmly into vehicle seat pressing down
near the crotch strap between the child's legs
removing slack from lap belt. Repeat for shoulder belt.
6. Make sure that vehicle belt buckle and hardware
DO NOT INTERFERE with the Infant Carrier.
34
a
Shoulder Belt Guide .
to see how your
a
, while
b
1
2
4
5
a
a
b
6
3