Using The Load Leg - CYBEX Aton 2 Manual Del Propietário

The Load Leg is an effective safety feature of the Aton 2 and using it is
STRONGLY RECOMMENDED. However, if necessary (e.g. in a center position
with a hump in the oor), the Base may be installed with the Load Leg folded
up underneath.
If ALL installation requirements for the Load Leg cannot be met, you MUST
choose another seating position, or install the Infant Carrier without the Base.
WHEN POSSIBLE, INSTALL the Aton 2 Base in a seating position that will
allow the Load Leg Foot to be extended into a LOCKED position with rm
contact with the vehicle oor.
NEVER INSTALL the Aton 2 Base in a seating position where the Load Leg,
even in its shortest position, causes the Base to be pushed up above the
vehicle seat. If necessary, the Base may be installed with the Load Leg
folded up underneath.
NEVER EXTEND the Load Leg Foot beyond the FIRST hole that will lock it
rmly against the vehicle oor.
To Extend
1. Install the Base making sure Recline Angle is correct for your child.
2. Squeeze the Adjustment Handle on the Load Leg and
extend the Foot until it rests on the vehicle oor.
3. Secure the Foot into place using the rst hole that will lock it rmly
against the vehicle oor without lifting the Base up off of the seat.
It may be necessary to lift up slightly on the Base to allow the Foot to lock
into the hole.
To Retract
Squeeze Handle and retract Foot.
24

Using the Load Leg

1
There should NEVER be any
space between the Load Leg
Foot and the vehicle oor.
The Base should NEVER
be pushed up above the
vehicle seat.
Use the FIRST hole
that will lock the
Load Leg Foot rmly
against vehicle oor
2