Attaching The 3-Brush Sweeping System Attachment - Kärcher MC 250 Implementos

9. Extend the changing carriage together with the 3-brush
system (without suction mouth).
10.Raise and secure the waste container.
Lynch pin (retainer)
1
Holder with suction hose
2
Water connections
3
11.Release the retainer at the holder.
12.Disconnect both water connections.
13.Pull the holder with the attached suction hose upwards
and out.
14.Pull the suction mouth out from under the vehicle.
15.Store the sweeping system safely in a dry place.
1.4.4 Attaching the 3-brush sweeping system
attachment
 Attachment of the sweeping system is described using
the optionally available changing carriage. The corre-
sponding > Sweep < program must be selected on the
display.
Symbolic figure: The 2-brush sweeping system with the
changing carriage is shown here
Mounting arm
1
Carrier connection between the vehicle and the suction
2
mouth
Changing carriage
3
The sweeping system is attached to the vehicle in the re-
verse order to removal, which is why the pictorial rep-
resentation is partially omitted here.
16.Stop the vehicle on level, solid ground and secure it
against rolling away.
17.Select the appropriate > Sweep < program on the dis-
play.
Suction mouth
1
Rollers
2
Suction hose connection
3
Vehicle
4
18.Position the suction mouth under the vehicle.
19.Open the locks (left and right). See chapter "Opening /
closing the lock".
20.Move the changing carriage, with the sweeping system
on top, under the vehicle using a lift truck. Move the fas-
tening arm (left / right) into the holder all the way to the
end stop. Check for correct seating before locking.
21.Close the lock (screw) and thus the attachment.
Carrier connection
1
Screw
2
Eyebolt
3
Lock-nut
4
22.Attach the carrier connection between the vehicle and
the suction mouth (left / right). Adjust the carrier connec-
tion (102 ± 0.5mm) on initial attachment to the vehicle.
23.Raise and secure the waste container.
24.Guide both water connections upwards.
25.Guide the holder with the attached suction hose down
to the suction mouth and lock in place.
26.Attach the suction hose to the suction mouth (hose
clip).
27.Depressurise the front hydraulic system. See chapter
"Depressurizing the hydraulic system".
28.Connect the hydraulic hoses, water connections and
power supply. Note the connection colours of the hy-
draulic hoses.
English 29