Start Up; Power Connection; Attach The Brush/Pad - Kärcher BDS 33/190 C Manual Original

Check the mains cable regularly for
damage such as aging or formation of
cracks. If you find a damage, then the
cable must be replaced before using it
any further.
Check appliance for damage, have
damages repaired by customer service.

Power connection

For connection values, see technical
–
data and type plate.
The electrical connections must be
–
done by an electrician according to IEC
60364-1.
Danger
Risk of electric shock.
Do not drive over the mains cable.
–
Danger
Risk of injury.
Never wrap the mains cable around
–
your body or your neck.
Do not let the mains cable come in con-
–
tact with the rotating brushes or rotating
pads.
Caution
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of
confusion regarding the power impedance
present on your connection, please contact
your utilities provider.
14

Start up

Attach the brush/pad

Disconnect the mains plug from the
socket.
Pull the lever for level adjustment and
bring the handle toward the front into a
vertical position.
Tilt the appliance rearward.
Place the disc brush/driver plate onto
the actuator and turn in anti-clockwise
direction.
Install the detergent tank (option)
1 Upper holder
2 Lower holder
Undo the star handle screws on the top and
bottom supports.
Hang the detergent tank (option) into the
lower support.
Align and affix the detergent tank (option)
by sliding the two supports.
Screw the star handle screws onto the sup-
ports.
– 3
EN