3-Brush Sweeping System Attachment Kit (Front Brush) - Kärcher MC 130 Classic Manual Del Usuario

3-brush sweeping system attachment kit
(front brush)
Installing the sweeping system
The pallet on which the sweeper system is delivered is also used
as a mounting aid for attachment/removal.
Pallet
1
Sweeping system
2
1. Move the lift truck under the pallet with the positioned sweeper
system.
Holder on the vehicle
1
Suction mouth installed
2
Sweeping system
3
Pallet
4
2. Pull the locking lever upwards.
3. Position the sweeper system approximately 10 cm in front of
the vehicle.
4. Connect the hydraulic hoses, paying attention to the colour
coding.
The connection assignments are described in a later chapter
5. Connect the water hoses.
6. Plugging in the electrical socket plug connection on the vehi-
cle.
7. Insert the sweeper system into the vehicle mounting bracket,
all the way to the end stop.
8. Lock the sweeper system by pressing the locking lever down
(using the curved rod).
9. The locking mechanism must be adjusted correctly via the ad-
justing nuts when the system is attached for the first time or
transferred to another vehicle. When correctly adjusted, the
locking mechanism must engage when pressed down beyond
the dead point.
10.Attach the side brushes and front brush.
View of the device for a 3-brush sweeping system
Front brush
1
Front brush arm
2
2-brush sweeping system
3
Slide
4
Device detection plug
5
1. Operation of the sweeper system is described in a later chap-
ter.
Connecting the high-pressure hoses and water hoses
Brush PTO
1
Tilt/roll front brush
2
Raise/lower front brush
3
Leakage oil
4
Pivot suction mouth/sweeping brush
5
Raise/lower sweeping brush
6
Pivot front brush
7
PTO 80 l/min
8
Brush PTO
9
Right-hand water connection
10
Left-hand water connection
11
1. Plug in the hydraulic hoses according to the colour coding.
2. Plug in the water hoses at the left and right sides.
English 93