Zumtobel ONLITE central eBox Serie Puesta En Operación Rápida página 44

Connecting an ONLITE central eBox SUB IP65 external sub-distribution unit
Note
i
Use the additional material supplied for connecting the external sub-distribution unit.
Connecting an ONLITE central eBox SUB E30 external sub-distribution unit
Note
i
·
Knowledge in the areas of fire protection and functional integrity is required for setting up,
mounting and installing an ONLITE central eBox SUB E30 external sub-distribution unit.
·
Relevant health and safety regulations as well as country-specific fire protection standards must
be observed.
·
Use the additional material supplied for connecting the external sub-distribution unit.
ONLITE central eBox, Quick commissioning 3.0 | 03.2019 | en
1. Open external sub-distribution unit ONLITE central eBox SUB IP65.
2. In the sub-distribution unit, remove the covers at the top and bottom.
3. Remove the knockouts at the top of the sub-distribution unit with a
screwdriver.
4. Route every cable connected to the external sub-distribution unit to the top
of the sub-distribution unit.
5. Fix all cables connected to the external sub-distribution unit to the strain
relief rail.
6. Connect the protective earth conductor to the earthing bar.
7. Connect conductors L, N, B+ and B- to terminals L, N, B+ and B- on the
external sub-distribution unit corresponding to the slot number of the sub-
distribution unit connection (SUB 2 – SUB 5).
8. Connect the system bus to terminals B1 and B2.
9. Ensure that the DC and AC voltage have been correctly wired.
1. Open external sub-distribution unit ONLITE central eBox SUB E30.
2. In the sub-distribution unit, remove the covers at the top and bottom.
3. Route every cable connected to the external sub-distribution unit to the top
of sub-distribution unit ONLITE central eBox SUB E30 first.
Connecting an external sub-distribution unit
EN
9