Machine Assembly - GGP ITALY TR 250 J Manual De Instrucciones

6
EN

4. MACHINE ASSEMBLY

IMPORTANT
some of the components disassembled and the
fuel tank empty.
WARNING!
very carefully so as not to impair the safety
and efficiency of the machine. If in doubt, con-
tact your dealer.
WARNING!
ing the assembly should be done on a flat and
stable surface, with enough space for moving
the machine and its packaging, always making
use of suitable equipment.
Disposal of the packaging should be done in ac-
cordance with the local regulations in force.
1. MOUNTING THE FRONT HANDGRIP (Fig. 1)
– Fit the sleeve (2) and the lower part (3) with
guard, placing the pin (3a) in one of the three
holes on the drive tube.
– Fit the front handgrip (4) by using the screws (5).
– Before tightening the screws (4), align the hand-
grip correctly with respect to the drive tube.
– Fully tighten the screws (4).
2. MOUNTING THE GUARD (Fig. 2)
WARNING!
suitable for the machine model and the type of
cutting tool used, and fitted correctly to re-
spect the correct position of the line cutting
knife.
– Remove the guard plug (1) from the end of the
bottom part of the rod (2).
– Slide the guard (3) along the bottom part of the
rod (2).
– Secure the guard (3) to the support (4) using the
supplied bolts (5).
The machine is supplied with
Mount the components
Unpacking and complet-
he protection must be
3. MOUNTING THE ROD (Fig. 3)
– Pull out the stop pin (1) and push the lower part
of the rod (2) right down until the stop pin (1)
slots into the hole (3) in the rod. This is easier to
do if you rotate the bottom of the rod (2) slight-
ly in both directions. The pin (1) is in place
when it is completely lodged in the hole.
– Lastly, tighten the knob (4) securely.
4. REMOVING AND REFITTING
THE CUTTING LINE HEAD (Fig. 4)
– Block rotation of the shaft (2) with the proper
key.
– Remove the cutting line head (1) unscrewing it in
an anticlockwise direction.
When mounting,
– Fit the cutting line head (1) screwing it up in a
clockwise direction.
MACHINE ASSEMBLY