Mounting The Cutting Blade - TRAPP Master 1000 Manual De Instrucciones

www.trapp.com.br
Hold the protection skirt (1), fit it into the
guiding-hole (2) on the aluminium bar of the
transmission gearbox, place the footstrap (3), the
bolts (4), the fixing nut (5) and tighten them.
Warning!
Never operate your mower without the
 
protection skirt, specially if you are
using the nylon spool, because then
you won't have the limiting blade for
the cutting area and the motor will
burn from overcharging.
Using the equipment without the
 
protection skirt is considered loss of
warranty.
Make sure that the on/off key is in the "off"
 
position and that the cord is disconnected from
the power supply.
Place the equipment carefully on a flat surface
 
positioning the blade face-up and the handlebars
face-down.
4
5
6
7
3
2
Mounting the Protection Skirt

Mounting the Cutting Blade

8
1
4
Then put the locking pin (1) in the adjusting hole
 
on the washer (2) to coincide with the hole on
the blade's support base (3) to lock it into place.
Use the blade's mounting key (4) to loosen the
mounting nut (5), observing that the threading is
on the left. Remove the lock washer (6), the plain
washer (7) and place the blade (8).
To mount follow the reverse order in the same
 
sequence.
Warning!
Never hold the blade when you have to
 
tighten or loosen the mounting nut - you
might get badly hurt.
Never use blades with external diameter
 
over 25.5 cm.
When using the nylon filament spool obey
 
the maximum filament length (10 cm). Out
of specification length can lead to motor
burning and loss of warranty.
The cutting blade's fitting hole measures 1
 
inch (2.54 cm).
1
5
2
3
21