Main Components; Mounting The Handlebar - TRAPP Master 1000 Manual De Instrucciones

Blade locking pin
Allen key
(4 mm and 5 mm)
Blade attachment key
Transmission
gearbox
Blade
With the equipment supported safety, loosen the
four screws (2) and remove the clamp from the
handle (3), secure the right handle (6), observing
the hole (8), which must fit into the pin that
exists in the handle bracket (5). Accommodate
the power cord (4) as shown in the next figure,
approaching the clamp (3) and lightly tighten
the two screws on this side. Next, secure the
left handle (1) on the other side, also observing
the fit hole and tighten the respective screws
slightly. Only then, give final tightening on both
sides. Finally, with the lawnmower positioned on
the support belt in the working position, set the
distance between the handle bracket (5) and the
motor frame (7) as the most comfortable position
for working.
20

Main Components

On/off switch
Right-side
handlebar
Protection skirt

Mounting the Handlebar

Supporting
belt holder
Extension lock
Left-side
handlebar
Supporting belt
7
4
6
www.trapp.com.br
Motor
Plug
1
2
3
8
5