TRAPP Master 1000 Manual De Instrucciones página 24

Make sure that the on/off switch is in the "off"
 
position and that the extension cord is not
connected to the power source.
Put the equipment on a flat surface with
 
thespool face-up and the handlebars face-
down.
Next, put the locking pin (1) into the mounting
 
hole on the washer (2) to coincide with the
hole on the blade's support base (3) to lock it.
Next, attach the spool (4) to the quipment,
 
turning it counterclockwise.
Introduce the skirt (5) into the fitting guide (6)
 
until it locks.
Never use the equipment without the nylon
 
(7) cord cutting blade, which is attached to the
protection skirt.
How to Set the Nylon Filament Length
24
How to Assemble the Nylon Spool
1
5
4
3
Warning!
Don't use the nylon spool without the protection
skirt because that is where the cutting blade
that regulates the maximum length for the nylon
filament is found, which keeps the motor from
overcharging and consequent burning out.
Disconnect the equipment from the power
 
source.
Pull off the spool face (1) and then turn it to the
 
left if you want more length and to the right to
shorten it.
If filament length exceeds the ideal size it will
 
be cut by the blade mounted on the protection
skirt.
www.trapp.com.br
1
2
6 5