Intended Use - Hilti DD AF-CA Manual De Instrucciones

prepared and approved supply cord available from Hilti Customer Service. Check extension cords
at regular intervals and replace them if found to be damaged. Do not touch the supply cord or
extension cord if it is damaged while working. Disconnect the supply cord plug from the power
outlet. Damaged supply cords or extension cords present a risk of electric shock.
▶ Never operate the machine when it is dirty or wet. Dust (especially dust from conductive materials)
or dampness adhering to the surface of the machine may, under unfavorable conditions, lead to electric
shock. Dirty or dusty machines should thus be checked by Hilti Service at regular intervals, especially if
used frequently for working on conductive materials.
Workplace
▶ Approval must be obtained from the site engineer or architect prior to beginning drilling work.
Drilling work on buildings and other structures may influence the static equilibrium of the structure,
especially when steel reinforcing bars or load-bearing components are cut through.
▶ If the drill stand has not been fastened correctly, always move the machine mounted on the drill
stand all the way down in order to prevent the stand from falling over.
▶ Keep the supply cord, extension cord, water hose and vacuum hose away from rotating parts of
the machine.
▶ Use of the water collection system in conjunction with a wet-type industrial vacuum extractor is a
mandatory requirement for wet drilling overhead.
▶ Use of the vacuum securing method without an additional means of fastening is prohibited for
drilling in an upward direction.
▶ An additional means of securing the drill stand must be employed when the machine is secured
with the vacuum securing method (accessory) for horizontal drilling.
3 Description
3.1 Parts and operating controls
3.2 Control panel and display
Emergency stop button
@
Service indicator
;
Button and LED: Manual mode
=
3.3

Intended use

The DD AF-CA drilling feed unit, a diamond core drilling machine and a drill stand recommended by Hilti
together form an automatic diamond core drilling system suitable for wet core drilling in mineral materials.
• When in operation, the DD AF-CA must always be mounted on the drill stand.
• The drill stand must alway be secured using the anchor spindle and a suitable anchor.
• When in operation, the DD AF-CA must be connected to a cooling water supply that meets the minimum
specifications given in the technical data.
Comply with the safety rules and operating instructions for the accessories used.
18 English
Printed: 22.05.2019 | Doc-Nr: PUB / 5209129 / 000 / 07
1
Water flow regulator on the diamond core
@
drilling machine
Hose connection to the diamond core drilling
;
machine
Water supply connection
=
Drilling feed unit
%
Control panel and display &
Drill stand
(
Connector for electric power and communi-
)
cation
Diamond core drilling machine
+
2
%
&
Button and LED: CUT ASSIST Mode
Positioning buttons with LED
2077904
*2077904*