Selecting The Saw Blade; Setting The Cutting Height; Adjusting The Mitre Angle - Festool TKS 80 EBS Manual De Instrucciones

Speed control
The speed can be continuously adjusted be­
tween 1700 min and 3500 min
-1
justing wheel [2-7]. This enables you to opti­
mise the cutting speed to suit the respective
material.
n
[min ]
-1
0
1 ~ 1700
2 ~ 1900
3 ~ 2300
4 ~ 2700
5 ~ 3100
6 ~ 3500
The preselected motor speed is kept constant
through electronic control. This ensures a uni­
form cutting speed even when under load.
Overload safety device
The power supply is restricted if the power tool
is overloaded to extremes. The power supply is
disconnected completely if the motor jams for
some time. You will need to remove the load
and/or switch off the power tool before you can
use it again.
Temperature cut-out
To avoid the motor overheating, the power con­
sumption is limited at an excessive motor tem­
perature (e.g. if the pressure is too high while
working). If the temperature continues to rise,
the power tool switches off. It can only be
switched on again once the motor has cooled
sufficiently.
Brake
The saw blade is stopped electronically within
approx. 3 seconds of switching off the machine.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected during continuous
use. To put the power tool back into operation,
it must first be switched off and then on again.
using the ad­
-1
6
2 - 5
3 - 6
9.2

Selecting the saw blade

Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Colour
Yellow Wood
Red Laminated wooden pan­
els, plastic
Blue Aluminium, plastic
9.3

Setting the cutting height

To set the cutting height anywhere be­
tween 0 mm–80 mm:
► Turn the cutting height setting [5-5].
+ Increases the cutting height to 80 mm
- Decreases the cutting height to 0 mm
To ensure a precise saw cut, set the cut­
ting height 2 mm–5 mm greater than the
workpiece thickness.
For concealed cuts, the cutting height is
set in accordance with the required depth
of the concealed cut.
9.4

Adjusting the mitre angle

The saw blade can be swivelled between 0° and
45°, and can be precisely adjusted by ±2° to -2°
and 47°.
► Press and hold the mitre angle setting [5-3]
against the cutting height setting [5-5].
► Move the mitre angle setting [5-3] along the
scale [5-1] until the angle indicator [5-2]
points to the required angle.
► Release the mitre angle setting [5-3] and
cutting height setting [5-5].
For precision trimming work, swivel out the
saw blade by 2° beyond the two end positions in
each case:
Fine adjustment
► Set the mitre angle to 0° to set a fine ad­
justment of up to -2°.
Set the mitre angle to 45° to set a fine ad­
justment of up to 47°.
► Turn the rotary handle for fine adjust­
ment [5-4].
+ End position up to 47°
- End position up to -2°
0 Zero position
End positions 0° and 45° are active.
English
Material Symbol
35