Risk Of Burns; Assembling And Setting Up - Kompernaß KH 6002 Instrucciones De Uso

Risk of burns!

The hydraulic dampers become hot during training.
You must never touch them, and not directly after
training either.
Risks due to incorrect/
excessive training!
Please make absolutely sure you follow all the in-
structions contained in the chapter entitled „Training
instructions" from page 60 onwards.
Caution!
It is possible that oil could escape due to leakage of
the hydraulic dampers. To avoid soiling of the floor
or carpet, place the device on a level, non-slip un-
derlay.
Prevent liquids from entering the computer. The sen-
sitive electronics could get damaged. Protect the
computer against direct sunlight.
Never use force when handling the device.
Check regularly that all the screws, nuts and bolts
are tight. Self-locking nuts cannot come loose due to
vibrations. This feature, however, can only be guar-
anteed the first time the nuts are tightened.
If the stepper is ever disassembled, all the self-lok-
king nuts must be replaced with new ones.
If you do not need to use the device for a longer pe-
riod of time, remove the battery from the computer
or else it could leak and cause damage.

Assembling and setting up

Most of the device is supplied pre-assembled. Only a
few things need to be done in order to make it ready
for use.You will need a Phillips type screwdriver
(supplied).
q
1. Insert the two plastic feet
tube w If necessary, rotate the foot
slot fits into the recess of the floor tube
2. Screw the self-tapping screws
led holes on the underside of the floor tube
r
3. Screw the adjusting screw
the front frame.
- 57 -
e
w
q
into the rear floor
q until the
w
.
e
into the pre-dril-
r
into the thread on
w
.