Corghi LaserLine EM 9580 Plus Manual De Uso página 79

light turns off;
- during the entire measurement cycle with
all balancing programmes;
- during the Hidden Weight programme when
selecting the two planes behind the spokes.
LEDOFF: deactivated
Press the Kis knob or the ENTER button to select
the desired mode. The selected icon is enabled
if it is in the following configuration:
- press to confirm the selection made
and exit the function.
LASER activation/deactivation
It is possible to activate or deactivate the laser
when present on the machine.
After the list of the setting programmes is dis-
played:
- Select the LASER activation/deactivation icon
- Two icons will appear on the display that repres-
ent the possible LASER modes, as shown below:
LASER OFF.
LASER ON. In this configuration, the laser turns
on in the following cases:
for the manual application of all adhesive
weights.
IMPORTANT:
If the operator selected the adhesive weight ap-
plication configuration using a CLIP, in the Alu1
or Alu2 balancing programmes the laser will not
be activated as the weight will be applied using
the weight holder
In the Hidden Weight programme, the selection
of the two new positions behind the spokes is
done in the 6 o'clock position using the laser line.
Press the Kis knob or the ENTER button to select
the desired mode
The selected icon is enabled if it is in the following
configuration:
- press to confirm the selection made
and exit the function.
EM 9580 Plus - EM 9580 C Plus - Operator's manual
WARNING:
The list of the configuration programmes can be
displayed as follows:
Select the utility and configuration pro-
-
grammes icon;
Select the configuration programmes
-
icon;
- Select view other icons
Sensitivity Calibration
Calibrate when detecting that the setting condition
is out-of-tolerance or when the machine so requires
as the E 1 message is displayed.
Calibrate as follows:
1. Select the sensitivity calibration icon
. in the configuration program menu
.
2. Fit a wheel of average or larger dimensions
preferably with only small unbalance on the
wheel balancer;
3. activate spinning;
4. At the end of the spin, fix the calibration weight
supplied with the machine on the swinging
unit bell as indicated in figure 27;
icon.
UK
27
79