Corghi LaserLine EM 9580 Plus Manual De Uso página 73

weight values needed to balance the wheel
will be shown on the monitor. The execution
of the programme is interrupted, thus not
achieving the moderate improvement of
the end results. However, the optimisation
procedure can be run by selecting the OPT
continue procedure icon.
- At the end of the second spin, the indication
to invert the tyre mounting on the rim may be
displayed. If you do not want to invert it or
it is impossible to do so, select the disable
tyre inversion icon. the machine will provide
the instructions to complete the programme
without inversion.
The Enable tyre inversion icon restores the
inversion function.
- It is possible to exit the optimisation pro-
cedure at any time by simply selecting the
Exit key twice
- If a different working environment is recalled
between one step of the OPT programme
and the next one, the OPT procedure always
remains stored. Therefore, going back to the
start environment, the programme resumes
the execution from the point where it was
interrupted. This situation is possible when
the Temporary Exit icon is selected.
Weight Management Suite
Weight Management is a suite containing 4
programmes:
1. Hidden Weight
2. Split Weight
3. OPT Flash
4. Less Weight
Note: the Hidden Weight, Split Weight and OPT
Flash programmes are available even when
Weight Management is not enabled.
To access this suite you must:
• Select the icon Utility programmes.
• Select the icon Weight Management.
In this way you will access the main screen of
Weight Management, showing 4 icons:
1. The icon OPT Flash, for the unbalance min-
imisation program.
2. The icon Balancing programmes, which
unites all the available balancing pro-
grammes.
3. The icon Statistics, which visualises the stat-
istics relating to the use of the Less Weight
EM 9580 Plus - EM 9580 C Plus - Operator's manual
.
program.
4. The icon Less Weight, for the slow or fast
vehicles weight savings programs.
If programme ALU 1P or ALU 2P has been set to
"Auto" mode, the icon Hidden Weight will also
appear, while if the programme MOTORCYCLE
ALU has been set to "motorcycle" mode, the icon
Divide side weight will appear.
Note: for Balancing programmes refer to the
BALANCING PROGRAMMES paragraph.
Note: for the using the OPT Flash programme,
see the paragraph OPTIMISATION PRO-
GRAMME (OPT FLASH).
Weight savings programme
(Less Weight)
This programme allows you to obtain the optimum
balancing of the wheel, reducing the quantity of
weight to be applied to a minimum.
To access this programme you must:
• Select the icon Utility programmes.
• Select the icon Weight Management.
In this way you will access the main screen of
Weight Management, and the unbalance values
visualised will be automatically updated.
Selecting the icon Less Weight, it is possible
to choose between 2 different weight savings
programmes:
• Optimised programme for fast vehicle wheels.
• Optimised programme for slow vehicle wheels.
The status bar of the displayed screen will show:
• The Fast wheel icon, if the programme for fast
vehicle wheels has been selected.
• The Slow wheel icon, if the programme for slow
vehicle wheels has been selected.
Note: each time the machine is switched on,
if the Weight Management suite has been
activated, the Fast wheel programme is auto-
matically set.
At this point it is possible to perform the wheel
balancing, using the required balancing pro-
gramme.
At the end of the spin, if the wheel balancing is
not satisfactory, a screen will display the values
of the weights to be applied to the inner and
outer sides of the rim.
UK
73