Idiomas disponibles
Idiomas disponibles
4 TECHNICAL MANUAL
4.1
Handle use (in the event of a power failure)
In the event of a power or equipment failure(machine stoppage when the cylinder is
hot) it is essential to immediately isolate the ironing bands from the cylinder.
To do this, insert a thick, very damp cloth of the correct size (barely wrung out) into the machine
by operating it using the provided handle (the handle must be available at all times, its initial
position is on the right-hand machine panel).
Insert the handle in the hole in the right machine panel after having lifted the red flap up (to be
able to insert the handle as shown below). When the red flap is lifted, the machine cannot start
and an alarm will appear if START- STOP is pressed (Alarm 2).
Turn the handle anticlockwise continuously until the fabric has passed through the machine
several times and sufficiently to cool and protect the cylinder and the bands.
At least two people are needed to carry out this operation in an emergency, one or two people
to infeed the laundry while another turns the handle.
When the handle is removed, the flap swings down to its original position and activates a safety
contact that allows the machine to be started.
Red flap to be tilted to insert the handle
(remove the wing screw)
Handle, to be turned
anticlockwise
17
