Idiomas disponibles
Idiomas disponibles
IMPORTANT: The machine must not be stopped at high temperature, press the
"START- STOP" (1) button to switch to the cooling phase, it will stop automatically when the
temperature reaches 80°C. Do not stop the machine by pressing the emergency stop, which
should only be used in case of extreme necessity.
3.2
Control panel description
Power on the machine using the main switch located on the back right hand side of the machine
(the emergency stop must not be triggered).
At start-up and for a few seconds, the display shows the microprocessor version and then it
indicates "PRESS START".
1- "START-STOP" button
2- Increase ironing speed
3- Decrease ironing speed
4- Increase temperature
5- Lower temperature
6- Validation button
7- Button to access the maintenance menu (reserved for technical services)
3.3
Running a cycle
By pressing the "START-STOP" button directly, the drier-ironer starts at the speed and
temperature of the last completed cycle.
Note that at start-up, the machine preheats to 130°C (modifiable parameter) at reduced speed
(3m/min) and the speed cannot be modified during this phase.
Furthermore, for electrically heated machines, the fan motors are only activated when half the
set point temperature is reached.
During operation, the display shows the actual cylinder temperature and rotation speed (run
screen), and these parameters can be changed using the corresponding buttons.
2
7
1
3
4
6
5
14
