Idiomas disponibles
Idiomas disponibles
FAULT
To carry out this operation, proceed as follows.
Switch the appliance off and leave it to cool.
1)
Turn off the circuit-breaker to disconnect it
2)
from the electrical mains.
Remove the bottom plate (C) and the grid (D)
3)
from the oven and clean them thoroughly.
Clean the inside parts of the oven to remove
4)
any deposits which may impair its operation.
Dry the surfaces and reassemble the compo-
5)
nents.
Clean the rubber gasket on the oven door
6)
(avoid the use of corrosive products and
do not use abrasive materials or sharp
tools).
The appliance has been tested before being
put into service. The information provided be-
low is intended to assist in the identifi cation
and correction of any anomalies and malfunc-
tions which might occur during use.
The user can solve some of these problems him-
self, but for others specifi c technical knowledge
or skill is required, and so they must only be car-
Faults
Smell of gas.
The pilot light does not
ignite.
3301360_ut_GB_rev.2
CLEANING OVEN
ged, do not use the oven and contact the
after-sales service.
FAULT
TROUBLESHOOTING
ried out by qualifi ed staff with recognised experi-
ence acquired in the specifi c sector of operation.
For any need, please contact Angelo Po's
agents or headquarters, which can be
found in the contacts section of the website
www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The spark ignition devices are
not working.
Air in pipelines due to long
period out of use.
D
IMPORTANT:
If the gasket is dama-
NOTE:
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order. Light
by hand with a naked light.
NOTE: Contact the
after-sales service.
Make more attempts to light
the fl ame.
ENGLISH
C
27
