Idiomas disponibles
Idiomas disponibles
• Twist the shaft slightly until the unlocking pin (11)
engages.
• Now tighten the locking screw (12).
The cutting device is disassembled in reverse
order.
9.2 Attaching the carrying strap (28) (Fig. 12-14)
The 4 in 1 multifunction device must be used with the
carrying strap (28).
• Attach the carrying strap (28) (see Fig. 13 and 14).
• Adjust the length of the belt so that the carabiner
hook (a) is approx. one hand-width beneath the
right hip.
• You can attach the 4 in 1 multifunction device to the
carrying strap (28) in different positions depending
on the attachment device and the fill level of the
fuel tank (8).
• Hook the 4 in 1 multifunction device in a suitable
position to the lifting eye (2) using the carabiner
hook (a).
• Allow the 4 in 1 multifunction device to swing.
Attention!
• The cutting tool on the brush cutter / grass trimmer
(13) must not touch the floor in the normal working
position.
• When using the hedge trimmer (17) or pole-mount-
ed pruner (21), the 4 in 1 multifunction device
should be swung horizontally.
• Do not start the 4 in 1 multifunction device while it is
hooked to the carrying strap! Only hook the device
to the lifting eye (2) using the carabiner hook (a) of
the carrying strap (28) with the engine running.
Safety tab on the carrying strap
• ATTENTION! In an emergency, the safety tab (b)
on the carrying strap (28) can be pulled. The ma-
chine then immediately detaches from the carrying
strap (28) and falls to the floor.
9.3 Mixing fuel
m Risk of injury! Petrol is explosive!
Switch off the engine and allow it to cool!
Wear protective gloves!
Avoid skin and eye contact!
You must observe the "Safety instructions" section.
• Only refuel the tank outdoors or in sufficiently ven-
tilated rooms.
• Clean the area surrounding the fuel tank cap (8).
Impurities in the tank lead to operational faults.
• Shake the container with the fuel mixture again be-
fore filling it into the tank.
• Carefully open the fuel tank cap (8) so that any pos-
sible excess pressure can be relieved.
• Carefully fill the fuel mixture up to the lower edge of
the fuel tank (8) filler neck. Use a funnel or a filling
aid to prevent spilling of the fuel.
52 | GB
• Close the fuel tank cap (8) again. Ensure that the
fuel cap is tightly sealed.
• Clean the fuel cap and the surroundings.
• Check the fuel tank (8) and fuel lines for leaks.
• Move at least three meters away from the refuelling
area before starting the engine.
9.3.1 Draining the fuel
Only empty the fuel tank (8) outdoors or in
well-ventilated rooms. Make sure that no fuel
gets into the soil (environmental protection). Use
a suitable surface.
• Hold a collection bucket under the fuel tank (8).
• Unscrew and remove the fuel cap of the fuel tank
(8).
• Drain the petrol/oil mixture completely.
• Retighten the fuel cap by hand.
10. Operation
Never operate the engine drive unit (1) without
the brush cutter / grass trimmer (13), hedge trim-
mer (17) or pole-mounted pruner (21).
10.1 Starting the device
Do not start the device until you have fully assembled
it.
m Risk of injury!
Only start the 4 in 1 multifunction device when
a cutting device is connected! Remove the cor-
responding transport protection and inspect the
device to ensure that its operating status is good.
Never use a cutting device that is damaged, poor-
ly adjusted or maintained, or not fully mounted
and secured.
Check before use!
Check that the device is in a safe condition:
• Check the device for leaks.
• Check the device for visible damage.
• Check that all parts of the device are securely at-
tached.
• Check that all safety devices are in good condition
and functional.
10.1.1 Starting up (Fig. 1, 15)
Once the device is properly assembled, start the en-
gine as follows:
Starting the engine when cold:
1. Pull the on/off switch (3) back to the on position.
2. Turn the choke lever (47) to the
3. Press the fuel pump (48) 7 times.
4. Pull the handle of the starter cable (7) 3 to 5 times
to start the engine.
ATTENTION! Never put a foot on the engine drive
unit (1) or kneel on it.
www.scheppach.com
position.
