Idiomas disponibles
Idiomas disponibles
SP-900-Install.book Seite 37 Montag, 25. Januar 2010 4:53 16
CoolAir
5.3.2 Installing the condenser unit
To install the condenser unit using a vehicle-specific WAECO fastening
frame, please observe the instructions included in the frame's scope of
delivery. The following work steps describe the installation of the con-
denser unit without vehicle-specific fastening frame.
Caution
Before drilling any holes, make sure that no electrical cables or other parts
of the vehicle can be damaged.
➤ Use the enclosed template (cardboard print) to determine the
➤ Use a felt pen to mark the positions selected for the holes.
➤ Drill fastening holes (Ø 9 mm) at the marked positions.
Apply anti-oxidant compound to all drilled through-holes to prevent
rust formation.
➤ Remove the eight hex screws from the housing of the condenser unit.
➤ Remove the housing and place it to the side (see Fig. 4 on page 4).
➤ Fasten the condenser unit using the four M8 x 18 screws, the
The panelling can only be fitted once the refrigerant lines and the cables
(see chapter "Connecting the condenser unit to the evaporator unit" on
page 39) have been connected.
I
a
position of the condenser unit. Six holes for fastening are marked on
the template.
I
AD Ø 40 mm washers (inside) and the M8 retainer nuts
(see Fig. 5 on page 5).
I
Installation
37
