Idiomas disponibles
Idiomas disponibles
Adjustment of horizontal / vertical angular position of saw
The machine is preset at the factory. If, however, it is not possible to achieve exact horizontal /
vertical cuts, the saw unit can still be readjusted.
Setting the measurement scale
The machine is preset at the factory. If, however, it is not possible to achieve exact cuts, the display
arrow for the dimension scale can be readjusted..
16.3 Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that
unauthorised persons and especially children do not have access to the machine.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
HOLZMANN Maschinen GmbH
Change the middle plate support:
Remove the plastic supports (4) of the middle plate
support by loosening the nut (5) from the pivot rod (6) and
replace with new ones.
NOTE:
plastic supports are machined directly with the saw. Set
the saw on the dimensional scale (2b) middle support in
the 0-position and mill/cut the plastic supports in the
swiveled position by means of a horizontal cut.
To re-adjust the horizontal cutting position, adjust the
position of the stop 1a and the fixing ring by loosening
the screws (1) and (2).
The control of the vertical cutting position 2a must also
be checked during the changeover in order to achieve
the correct cutting position for both end positions..
For readjustment, correct the dimensional deviation of
the stop to the finished workpiece by changing the
indicator arrow (2). To do this, loosen the screw (3),
change the display arrow (2) to the scale (4) by the
dimensional deviation and fix the position again by
tightening the screw (3).
Same procedure for both dimensional stops..
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
To obtain an aligned support to the saw unit, the
N O TE
43
VPS3216ECO_230V
