Idiomas disponibles
Idiomas disponibles
Vacuum the wood chips and sawdust. Wipe off any remaining dust with a dry cloth.
•
•
Use a resin-dissolving cleaner for resin build-up.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
•
(e.g. WD40 rust inhibitor).
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
•
Before each operation, check the perfect condition of the safety devices.
Check the condition and tight fit of the saw blade and the saw blade guard before every
•
operation.
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only proper and suitable tools.
•
•
Use only original spare parts recommended by the manufacturer.
Repair work may only be carried out by qualified personnel.
•
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before usage
Once a week
Once a month
If necessary
Assembling/deassembling saw blade
Follow the insructions of TAS165PRO user manual.
Changing the plate supports
Due to wear, it may be necessary to replace the middle or lower plate supports..
HOLZMANN Maschinen GmbH
Components
Machine
Loose fixing bolts, screws
Guide track and roller guide of
sliding table and rip fence
Moving parts
Maintenance room
Saw blade, scoring saw blade
Plate supports
Change the wooden support of the lower plate support:
Remove the sliding surfaces (2) from the wooden support
(3). Then disassemble the wooden support (3) by
removing the fastener (1) from the machine.
Determine the thickness of the sliding surfaces (2).
Reattach the new wooden supports (3) to the machine.
NOTE:
wooden supports are machined directly with the saw and
the thickness of the sliding surfaces (2) in the wooden
support (3) is milled/cut. Afterwards, the sliding surfaces
are reattached to the wooden support by means of the 3
screws.
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Clean
Check for tight fit, tighten if necessary
Clean, blow out
Lubricate
Vacuum chips
Clean the motor housing
Change
Change
To obtain an aligned support to the saw unit, the
Action
VPS3216ECO_230V
42
