Husqvarna K1 PACE Manual Del Usuario página 36

Symbol on the control pan-
el
Transportation and storage
CAUTION:
to the product during transport of the
product. The rail fixture is a precision tool.
A damaged tool gives less accurate cuts.
• Attach the product safely during transportation to
prevent damage and accidents.
• Remove the cutting blade before transportation or
storage of the product.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the cutting blades in dry, frost free conditions.
• Examine all new and used blades for transport and
storage damage before assembly.
• Clean the product and do the maintenance before
Maintenance schedule on page 32 .
storage. Refer to
36
Problem
The yellow temperature
warning indicator is on.
The X-Halt indicator flash-
es.
The X-Halt indicator is on.
1 green LED flashes.
All green LEDs flash.
LED 3 flashes and LED 4 is
on permanently.
Rail fixture indicator is on
when the rail fixture is at-
tached to the product.
Transportation, storage and disposal
Do not install the rail fixture
Cause
Temperature deviation.
The X-Halt function is en-
gaged.
Servicing is necessary.
Low battery voltage.
Servicing is necessary.
Servicing is necessary.
The rail fixture is not at-
tached correctly.
• Disconnect the battery from the product.
• When you put the K1 PACE Rail in its transportation
box, make sure that the rail fixture and the product
do not touch.
Disposal of the battery, battery charger
and product
The symbol below means that the product is not
domestic waste. Recycle it at a recycling station
for electrical and electronic equipment. This helps to
prevent damage to the environment and to persons.
Speak to local authorities, domestic waste service or
your dealer for more information.
Solution
The product is too hot or
too cold.
Wait for the cool down peri-
od to complete.
Speak to an approved
Husqvarna service center.
Charge the battery.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
Make sure that the rail fix-
ture touches the bottom
end of the installation point
on the product. If the rail
fixture indicator is still on,
try the second installtion
point.
If the rail fixture indicator
goes off when it is attached
to the second installation
point, this installation point
operates correctly.
Speak to an approved
Husqvarna service center.
1598 - 007 - 28.09.2023