Husqvarna K1 PACE Manual Del Usuario página 33

To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring
operates correctly.
2. Push down the power trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
1598 - 007 - 28.09.2023
4. Push and hold the On/Off button to start the product
and apply full power. Refer to
page 26 .
5. Release the power trigger and make sure that the
cutting blade stops. If the cutting blade rotates when
the power trigger is in the idle position, speak to your
servicing dealer.
To clean the battery and the battery charger
WARNING:
the battery charger with water.
WARNING:
substances to clean the battery.
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To do a check of the battery charger
1. Make sure that the battery charger and the power
supply cord is not damaged. Look for cracks and
other damage.
To start the product on
Do not clean the battery or
Do not use any chemical
33