Husqvarna K1 PACE Manual Del Usuario página 28

2. Push and hold the On/Off button on the control panel
until the battery status indicator goes off.
3. Push the battery release button and remove the
battery from the battery holder.
WARNING:
you do not use or when you do not have
full vision of the product. This is to prevent
accidental start.
Rail cutting (K1 PACE Rail)
General
A rail fixture is used with rail power cutters to cut railroad
tracks. Always cut railroad tracks with abrasive blade
and no water. Speak to your servicing dealer for more
information about different rail fixtures.
WARNING:
gloves when you assemble or disassemble
the product.
28
Remove the battery when
Always use protective
CAUTION:
on the product during transport or when you
move the product. When the product and
the rail fixture are put together, there is a
larger risk of damage than when they are
disconnected. Damages, such as bent parts,
can result in less accurate cuts.
Installation points and rail fixture indicator
K1 PACE Rail has 2 installation points for the rail fixture,
on the left side and on the right side of the product.
The rail fixture indicator shows if the rail fixture is
attached or not attached to the product. When the rail
fixture is correctly attched to the product, the indicator
goes off. When the rail fixture is not attached to the
product, the indicator is on.
Do not install the rail fixture
1598 - 007 - 28.09.2023