Idiomas disponibles
Idiomas disponibles
Getting to Know Your GTS15-10 Table Saw
1
Power Switch is used to turn the tool on and
off. The power switch incorporates holes and a
rotating cover for use with a padlock to prevent
accidental starting.
2
Elevation Wheel elevates or lowers the blade.
Use with Blade Bevel Lock Handle 3 to tilt the
Blade 0° to 45°.
3
Blade Bevel Lock Handle locks the Blade to
de sired bevel angle.
4
Blade Bevel Scale shows the degree the Blade
is tilted.
5
Base supports the table saw. Holes in the Base
allow the saw to be bolted to a workbench or
stand.
6
Rail Lock Lever allows you to lock the Rip
Fence 9 at the desired distance from the Blade.
7
Rail Adjustment Knob is used to adjust the po-
sition of the Rip Fence 9.
8
Push Stick is a device used to feed the work-
piece through the saw during narrow ripping-
type operation. It helps keep the operator's
hands well away from the Blade.
9
Rip Fence attaches to the Rails 10 using the
locking latches and guides the workpiece par-
allel to the blade.
10 Rails provide mounting points for the Rip
Fence 9 at the front and rear of the saw.
11 Smart Guard System consists of an adjustable
three-position Riving Knife, an Anti-Kickback
Device, and a Barrier Guard Assembly. These
are part of a modular system that requires no
tools to assemble or disassemble. The Smart
Guard System must always be in place and
working properly for all through-sawing cuts.
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 13
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 13
12 Table Insert provides workpiece support near
the Blade. It can be removed to remove or in-
stall the Blade or other cutting tools and to
adjust or store the Riving Knife.
13 Table provides a large working surface to sup-
port workpiece and includes CLAMPZONE™ ar-
eas for clamping workpieces.
14 Miter Gauge head can be locked at the desired
angle for crosscutting or mitering by tightening
the Miter Gauge Lock Knob. ALWAYS SECURE-
LY LOCK THE MITER GAUGE WHEN IN USE.
15 Cord Wrap allows you to easily secure the
cord so it's out of the way when transporting
or storing.
16 Power Cord
17 Flip-Over Fence is attached to the Rip Fence
9. The Flip-Over Fence, in the lower position,
provides material support and, in the upper
position, provides support for workpieces 1/8
to 3/4 of an inch (3.2 to 20 mm) thick.
18 Dust Port/Vacuum Hook-Up allows you to at-
tach any 2-1/4" vacuum hose to the dust port
for convenient sawdust removal. An adaptor is
available for use with alternate hose sizes.
-13-
4/20/2023 11:23:06 AM
4/20/2023 11:23:06 AM
