Idiomas disponibles
Idiomas disponibles
Guard System 11 and all moving parts are working
properly. Periodically clean the Smart Guard Sys-
tem 11 with a rag or a brush.
The power cord and the tool should be wiped with
a dry clean cloth to prevent deterioration from oil
and grease.
Anti-Kickback Device Maintenance
(Fig. 93)
Make sure the teeth of the anti-kickback device are
always sharp. To sharpen:
1. Remove anti-kickback device from riving knife.
2. Rotate one pawl away from the other.
3. Hold pawl over corner of workbench.
4. Using a small round file (Smooth Cut) sharpen
the teeth.
Fig. 93
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 58
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 58
Maintenance and Lubrication
-58-
Clearing the Dust Port/Vacuum Hook-
Up
(Fig. 94)
Do not operate saw without
properly installed Dust Port/
Vacuum Hook-Up. Missing or improperly installed
chute can allow access to saw blade and result in
property damage or personal injury.
Thin cut-offs may fall through the Table Insert 12
and accumulate in the Dust Port/Vacuum Hook-Up
18 preventing dust extraction. The Dust Port/Vacu-
um Hook-Up 18 is removable to allow clearing out
of any dust and cut off buildup. To clear out the
Dust Chute:
1. Loosen the Dust Port/Vacuum Hook-Up Retain-
ing Screw 120.
2. Remove the Dust Port/Vacuum Hook-Up 18 by
sliding it away from the tool.
3. Clear any debris from the Dust Port/Vacuum
Hook-Up 18 and inside of the blade enclosure.
4. Reattach the Dust Port/Vacuum Hook-Up 18,
and secure it with the Dust Port Retainer Screw
120.
Fig. 94
18
18
120
120
4/20/2023 11:24:14 AM
4/20/2023 11:24:14 AM
