battioni Pagani MEC Serie Manual De Instrucciones De Uso Y Mantenimiento página 60

instruction manual
for use and maintenance serie MEC, STAR
3.7.2 Front disassembly
.../M-K
1) Unscrew the screws 1) Remove the driven
of the gearbox cover;
2) Use two screws for 2) Disassemble the
screwing into the
threaded extraction
holes until the cover
is removed; 3) Remove the screws
3) Remove the gear
with splined shaft 4) Slide the rotor from
using an extractor if
necessary;
5) Remove the seeger
4) For the pinion:
unscrew the self-
locking nut, use an
extractor; 6) Disassemble the
5) Remove the seeger
ring placed in front
of the bearing
6) Slide the rotor from
the body together
with the gearbox;
7) Disassemble the
rotor from the
gearbox through a
press;
3.8 RE-FITTING – RE-INSTALLATION
IMPORTANT: Before proceeding with any re-fitting, replace the gaskets of the opened parts.
3.8.1 Re-fitting of the back
1) Remove the bearing and the spacer from the back flange;
2) Replace the flange gasket;
3) Bring the back flange up to the pump body, aligning it with the clamping holes;
4) Insert the 6 clamping screws in the holes and tighten them;
5) Fit the bearing on the flange using a drift;
6) Insert the spacer;
7) Re-fit the back cover or the lubrication pump (together with the connector joint) on the flange.
pag. 42
.../P MEC 9000-11000-13500.../P
1) Remove the driven
pulley and the key; pulley and the key;
2) Remove the front
front cover from the cover from the
flange; flange;
3) Remove the seeger
from the front flange; ring from the front
pin;
the body; 4) Remove the screws
from the front flange.
ring placed in front of 5) Pull the rotor out from
the bearing; the body;
6) Use a press to remove
rotor from the the rotor from the
gearbox through a flange.
press;
SERIE MEC 1000-1600-2000-3000-4000-5000-6500-8000
.../D
1) Remove the flange 1) Disassemble the
with splined shaft;
2) Remove the sleeve
with transmission 2) Remove the
flange and key
3) Remove the seeger
ring placed in front 3) Remove the
of the bearing;
4) Remove the
clamping screw from
the splined hub;
5) Disassemble the rotor 4) Remove the
from the gearbox
through a press
5) Slide the rotor
6) Remove the
7) Disassemble the
.../H
hydraulic motor
from its support;
hydraulic motor
support;
clamping screw
located inside the
sleeve and then
slide the sleeve
out;
screws from the
front flange;
from the body;
seeger ring placed
in front of the
bearing;
rotor from the
gearbox through a
press;