Idiomas disponibles
Idiomas disponibles
instruction manual
for use and maintenance serie MEC, STAR
INSTRUCTIONS FOR USE AND MAINTENANCE
2.0 - PACKAGING, STORAGE, HANDLING AND TRANSPORT
2.1
PACKAGING
The Rotary blades vacuum pump are supplied without packaging. On request the following packaging can be used:
wooden base and shrink-wrap;
•
wooden cases and shrink-wrap for shipment by sea or air.
•
2.2
STORAGE
In order to preserve the Rotary blades vacuum pump correctly, it must be stored:
under cover, sheltered from adverse weather conditions;
•
resting horizontally on its four feet.
•
The Rotary blades vacuum pump are lubricated during testing at our factory with special oil that ensures lubrication of the various
internal components for approx. 6 months.
In the event of subsequent storage it is advisable to wash the inside of the body with oil and diesel oil (as stated on this manual).
2.3
HANDLING AND TRANSPORT
Mass of Rotary blades vacuum pump: (see tecnical sheet).
The Rotary blades vacuum pump should be:
•
Harnessed by means of metal hooks inserted in the hole for gripping, or a sling;
•
Lifted with a hoisting truck (if on pallet), bridge crane, or crane.
•
MEC 1000/1600 pumps must be lifted through a 1/4" gas eyebolt that has to be fitted instead of drain cock.
The Rotary blades vacuum pump is supplied with a guard that is in compliance with EC directives. This guard should be fitted on by
the fitter using the four screws supplied.
3.0 - ASSEMBL Y , FITTING, INSTALLATION, DISASSEMBL Y , RE-FITTING
The procedures concerning Rotary blades vacuum pump versions .../G and .../GA are given in the GARDA/GARDA EVO group
instructions.
When carrying out maintenance operations, inspections, checks and repairs you are advised to wear the individual
means of protection listed in this manual.
All maintenance operations, inspections, checks and repairs should be carried out with the greatest care and with
the tractor not running and the power take-off disconnected.
It is essential to prevent sewage from entering the Rotary blades vacuum pumps. The entrance of sewage would
cause the blades and consequently the rotor to break.
It is therefore necessary to equip the system with an overflow valve, "3", and a safety overflow valve, "2", between
the Rotary blades vacuum pump and the tank car (see Figure 1)
3.1 INSTALLATION DRAFT
7
7
pag. 36
9 8
5
3
9
8
5
3
7 6
7
6
4
2
4
2
1 - Pump
2 - Secondary shut-off valve
3 - Primary shut-off valve
4 - Silencer
5 - Motorized joint
6 - Swivel joint
7 - Stemgate
1
1
8 - Overpressure valve
9 - Depression valve
Figure 1
