Upgrading The Wheel Aligner Software; Enabling Extra Wheel Aligner Functions - Corghi EXACT 7000 Manual De Uso

CONNECTOR CABLE FOR
PC OUTPUT CONNEC-
TION
HHD To sensor
POWER cable/ra-
dio circuit
board
POWER Power supply
SUPPLY cable
(**): see instructions above.
N.B.: Some of these outputs may not feature on
the PC you are using.
ATTENTION
For technical specifications, precautions, main-
tenance and all other information concerning
the monitor or printer, refer to the relative op-
erator's manuals supplied with the equipment's
documentation.
Upgrading the wheel aligner
software
The wheel aligner is supplied with the software
already installed, and is complete with an instal-
lation CD-ROM.
After installing the EXACT 7000 wheel aligner
switch the equipment on and locate the initial
video page.
Press the È + F12 (caps shift + F12) keys; the
software release will appear in the top left-hand
corner of the screen, underneath the CORGHI
logo.
Compare the software release (indicated as "SW
STD ...") with that stated on the installation CD-
ROM supplied with the aligner.
If the CD-ROM release is more recent than the
release installed, update the aligner software.
Detailed information about the software update
procedure is provided in the leaflet accompany-
ing the CD-ROM.
Operator's Manual EXACT 7000
Enabling extra wheel aligner
TYPE
Extra wheel aligner functions are enabled by
upgrading its main protection card, marked with
HHD power
the
The upgrade is obtained by means of the "up-
grade card", received when the relative accessory
VDE plug
kit is ordered.
Upgrade cards carry specific identification
symbols; detailed information on upgrades'
identification is supplied in the leaflets which
accompany them.
To upgrade the main card, which must be inserted
in its slot in the reader, insert the upgrade card
in the slot "A" with the gilded contacts facing
upward and run the relative procedure using the
The upgrade card cannot be reused. However,
keep it for use if it becomes necessary to repro-
gram the main card of the wheel aligner for which
it was used the first time.
The
the system configuration:
CARD: card number 1 is the wheel aligner's main
card; card number 2 (if any) is an upgrade card.
HEADER: "MAS" aligner main card, "AGG" up-
grade card.
SERIAL: card serial number. For main cards
this number is unique. For upgrade cards the
number is 0 when they are new, while after use
it becomes the same as that of the main card
that has been upgraded.
DATE: card creation date.
VAS: "ON" VW/AUDI program on, "OFF" pro-
gram off.
MLK: "ON" MULTILINK suspension car program
on, "OFF" program off.
REN: "ON" RENAULT program on, "OFF" program
off The RENAULT program reverses the toe signs
for RENAULT vehicles only.
MER: "ON" MERCEDES program on, "OFF"
program off.
PHEATON: "ON" VW Phaeton and Touareg pro-
gram on, "OFF" program off.
functions
symbol.
, and
, and
icons.
icons display
GB
51