Standard Working Sequence - Corghi EXACT 7000 Manual De Uso

sTAnDARD WoRKInG
sEQUEnCE
Alignment procedure for 2-axle vehicles (cars).
1) Aligner switch-on
2) Start work.
3) Databank / Job record
4) Preparation for wheel alignment
5) Wheel diameter input
6) R.O.C.
7) Chassis clearance input
8) Angle measurement with steering locked to
10° or 20°
9) Data summary
10) Rear axle measurement
11) Front axle measurement
12) Angle measurement with steering locked
to 10° or 20°
13) Front axle measurement
14) Print out of data measured
(1) switching on the aligner
Power up the equipment using the master switch
(H Fig.22).
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
In this stage, the central unit runs a functional
self-diagnostics test and loads the operating
system; if everything is in order, the "Main menu"
screen will appear (fig. 33).
If the user setup field "Alignment customisation
procedure/Lift test" = YES, the program will
automatically open the "Lift Check" page, see
"Lift and Sensor Check" section.
(2) Work start selection (Fig.33)
To access this function from the rest of the pro-
gram select the
Select the wheel alignment mode
procedure and start work
restarts the previous job.
and
"demo" mode, for which the sensors are not
required. The "demo" mode is indicated by the
symbol in the status bar.
Operator's Manual EXACT 7000
icon or the F9 key.
and
.
enable and disable the
and
maintenance utilities, and wheel aligner cus-
tomisation.
ends execution of the program, shuts
down all the applications open and switches off
the wheel aligner.
allows selection of the wheel alignment
modes. The truck and trailer modes are only
enabled if the
been installed. The instructions for this mode are
provided in the manual supplied with the kit.
WARNING
before switching off the wheel aligner, always
shut down the active programs and operating
system correctly.
(3) Databank (Fig.34)
To access this function from the rest of the pro-
gram select the
Select the vehicle from the databank using the
keys as follows:↓, ↑, PAG↓, PAG↑, ←, → and
the letter keys to scroll the makes and model
descriptions;
↵ to confirm the vehicle selection.
During selection, the vehicle code is shown in
the status bar.
The model of the vehicle selected will be loaded
in the "Vehicle name bar", which contains the name
of the market set while selection is in progress. In
"car" alignment mode, the screen shows all the cars
and vans up to and including 3500 kg; in "truck"
alignment mode, it displays all the trucks and vans
up to and including 3500 kg.
recalls the market selection. The screen
only shows the vehicles on sale on the selected
market.
allows selection of the reference data-
bank. The vehicles belonging to the user data-
bank are marked by the
access the service and
truck upgrade has
icon or the F8 key.
symbol.
69
GB