Korg MS-20M Manual De Usuario página 6

4. Attaching the switch VR circuit board to the top panel with the included nuts (B)
Disconnect the wiring harness (to be connected to the panel jack circuit board) from the switch VR circuit board, and then attach
the switch VR circuit board to the top panel.
Make sure that the orientation is correct by aligning the guide pins with the guide holes on the panel, and then secure it with the
included nuts (B).
Caution: Be careful that the panel is not scratched when the included box-end wrench is used to tighten the nuts
switch VR circuit board
5. Attaching the TRIG SW button to the top panel with the nut (B)
Attach the TRIG SW button to the top panel, and then secure it with the nut (B).
6. Installing the spacer sheet on the panel jack circuit board with the nut (A)
Make sure that the three LEDs are correctly positioned, and then install the spacer sheet.
Secure all of the jacks with the included nuts (A).
Caution: Be sure to firmly tighten the nuts so the spacer sheet does not move out of place.
Caution: Be careful that the LEDs are not scratched with the tools.
Nut (A)
6
TRIG SW button
Nut (B)
guide pin