NOTE:
If a torque wrench is not available when
you are installing the drain plug, finger
tighten the bolt just until the gasket
comes into contact with the surface of the
drain hole. Then tighten 1/4 - 1/2 turn.
Have the drain plug torqued to the correct
value with a torque wrench as soon as
possible.
4) Remove the oil filler cap 2. Add the
correct amount of oil through the
filler hole.
w
Reinstall the filler cap.
Engine oil grade/capacity:
Refer to "SPECIFICATIONS", page 4-1.
5) Start the engine and watch to make
203011*
sure the low oil pressure warning
lamp turns off. Make sure that there
are no oil leaks.
cC
If the oil lamp does not turn off, or if
there are oil leaks, stop the engine and
find the cause. Continued operation with
a problem could cause severe engine
damage. If the problem cannot be found
and corrected, consult your Yamaha deal-
er.
6) Turn off the engine and wait 3 min-
utes. Recheck the oil level using the
dipstick to be sure the level falls
between the upper and lower marks.
Fill with oil if it is below the lower
mark, or drain to the specified level if
it is above the upper mark.
7) Dispose of used oil according to local
regulations.
201011
4-17
GB
