Operation Mode; Recalling The Data; Measurement With The Desired Systolic Pressure - AND UA-1020-W Manual De Instrucciones

1. Normal Measurement
Press the START button. Blood pressure is measured and data is stored
within the device. The device can store the last ninety sets of data in
memory automatically.

2. Recalling the Data

Press the or
memory. The average of all measurements is
displayed, as indicated in the figure at the right.
Then, each time the
memory data is displayed as follows.
Average of all AM (morning) measurements
taken between 4:00 and 9:59.
Average of all PM (evening) measurements
taken between 18:00 and 1:59.
Most recent data (No.n, in the example,
No.35)
Last data (No.1)
For details on recalling the data, refer to the
section "Recalling the Memory Data". (Refer
to page 18)
3. Deleting all Data Stored in Memory
Press both the
and the battery indicator appear. Press and hold
both the and
mark starts blinking to delete all data stored in
memory.

4. Measurement with the Desired Systolic Pressure

Refer to page 15 for measurement with the desired systolic pressure.

Operation Mode

button to recall the data in
button is pressed, the
and buttons. The
buttons until the illuminated
English 7
mark