Idiomas disponibles
Idiomas disponibles
8. MAINTENANCE
WARNING
The manufacturer will not bear any responsibility
in the event of claims resulting from the use of
non-original spare parts or accessories.
WARNING
Unplug the machine from the socket and make
sure that all moving parts have been locked
before performing any adjustment or mainte-
nance operation.
WARNING
Do not remove or modify any part of the machine
(except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water
to remove dirt or residues from the machine.
Take all possible measures to prevent dust from
building up or rising during cleaning operations.
Keep the wheel balancer shaft, the securing ring
nut, the centering cones and flange clean. These
com¬ponents can be cleaned using a brush
previously dripped in environmentally friendly
solvents. Handle cones and flanges carefully so
as to avoid accidental dropping and subsequent
damage that would affect centering accuracy. After
use, store cones and flanges in a place where
they are suitably protected from dust and dirt. If
necessary, use ethyl alcohol to clean the display
panel. Perform the calibration procedure at least
once every six months.
LUBRICATION
The only rotating parts of the wheel balancer are
the motor and balance shaft. These parts must
be periodically lubricated by the operators. If
the machine is used very frequently, more than
2hours per day, we should annually check the
bearing. And we will check once a year if the
machine is used less than 2hours a day. When
test, do not open up the bearing so you need
insert a screwdriver to test the noise . Due to
the function of the bearing is to clamp and
support and not suitable to change or remove
the grease. In addition, the speed of it is not
ProLine 60 - Operator's Manual
too fast compared to the machine so no need
to change the grease. If you note the run of the
bearing abnormal or there is noise, change the
bearing. If the customer confirms the bearing is
not changed, you only need change the grease.
Disassemble the bearing and open up the sealing
ring and fill the XHP103 grease. These operation
should be guided by the profession personnel
and calibrate the machine after changing the
grease. If the change of the grease not correctly,
it will influence the accuracy of the machine. On
this condition, you need to reinstall the sealing
ring and assemble the machine and adjust again.
Technical safety card for using grease in the
wheel balancer
Mobilgrease .................................................... XHP
NLGI ........................................................... degree
Type of thickener ............................... Li-complex
Colour, appearance .............................. Dark blue
Penetration on the processed item 25°,
ASTM D 217, mm/10 .........................................235
Dropping point, °C, ASTM D 2265 .................280
Viscosity oil base, ASTM D 445,
cSt @ 40°C .........................................................100
Change of penetration consistency,
ASMT D ...........................................................1831
(established upon the rolling of the greases),
mm/10 ..................................................................10
4 spheres test, impression diam., ASTM D 2266,
mm ......................................................................0.5
4 spheres test, welding load,
ASTM D 2509, kg ..............................................315
Test Timken OK load, ASTM D 2509, lb ..........45
Stability of oxidization bomb method,
ASTM D 942, pressure drop at 100 hours,
kPa .......................................................................35
Corrosion prevention, ASTM D 1743 ...... Passed
Emcor rust, IP 220,
wash away with acid water ..................................0
Rust protection, IP 220-mod,
wash away with distilled water ...........................0
Corrosion on copper, ASTM D 4048 ................ 1A
Resistance to water spray,
ASTM D 4049, % spray .......................................15
Wash away with water, ASMT D 1264,
loss (weight%), @ 79°C.........................................5
UK
51
