Instructions For Use And Maintenance Of The Hydraulic Motor - battioni Pagani BALLAST 3500 Manual De Instrucciones De Uso Y Mantenimiento

HYDRAULIC INSTALLATION WITH
UNIDIRECTIONAL MOTOR
1 Hydraulic pump
2 Over-pressure valve
3 Radiator
4 Oil filter
4) Then connect the intake/compression pipe of the tank car to the rotary blades vacuum pump tightening it to the adjustable elbow
using metal clamping bands in relation to the diameter of the pipe.

3.5 INSTRUCTIONS FOR USE AND MAINTENANCE OF THE HYDRAULIC MOTOR

Make sure take the rotation of the unidirectional motor is the proper are for your system. Make sure take there is good linear
matching between motor shift and power take off.
TANK. The tank capacity must be sufficient for the system's operating conditions ( ~ 3 times the amount of oil in circulation) to
avoid overheating of the fluid. A heat exchanger should be installed if necessary. The intake and return lines in the tank must be
spaced apart (by inserting a vertical divider) to prevent the return-line oil from being taken up again immediately.
LINES. The lines must have a nominal diameter which is at least as large as the openings of the engine and must be perfectly sealed.
A length of flexible tubing is recommended to reduce the transmission of vibrations. All return lines must end below the minimum
oil level, to prevent foaming.
FILTERS. We recommend filtering the entire system flow rate.
HYDRAULIC FLUID. Use hydraulic fluid conforming to the ISO/DIN standards. Avoid using mixtures of different oils which
could result in decomposition and reduction of the oil's lubricating power.
instruction manual BALLAST series
HYDRAULIC INSTALLATION WITH
BIDIRECTIONAL MOTOR
5 Oil tank
6 Hydraulic motor
7 Distributor
8 Drainage
user and maintenance
p. 39