Kärcher MC 130 Classic Manual Del Usuario página 103

Replace a heavily soiled or damaged filter cartridge with a new
one.
12.After assembly, pivot the complete air filter unit inwards and
tighten it using the wing screw.
Changing the dust filter on the outer cabin
Cover
1
Dust filter
2
Note
Fine filter filter grade F8 (available as option)
1. Unscrew the 6 screws for the cover.
2. Remove the cover.
3. Take out the dust filter.
4. Blow out the slightly contaminated dust filter using com-
pressed air (reduced pressure). Renew severely contaminat-
ed dust filter.
5. Insert the new or cleaned filter.
Replace the dust filter in the cab interior
Driver's seat
1
Dust filter
2
Passenger seat
3
1. Push both seats forwards.
2. Remove the dust filter.
3. Check/clean the dust filter, replace if necessary.
Installation information
Ensure the correct mounting position on re-installation.
Changing a wheel
DANGER
Risk of fatal injury from flowing road traffic
Bring the vehicle out of the hazard zone of flowing road traffic be-
fore starting any repair work.
Switch on the warning flashers.
Erect a warning triangle.
Don warning clothing.
Note
Use a suitable, commonly available jack.
Wheel nuts
1
Wheel
2
1. Park the vehicle on level and solid ground.
2. Engage the parking brake and additionally secure the vehicle
against rolling away.
3. Secure the articulated joint.
4. Remove the ignition key.
5. Use a suitable tool to release the wheel nuts by approx. 1 turn.
6. Fit the jack to the appropriate mounting point at the front or
rear wheel and raise the vehicle with the jack.
7. Additionally support the vehicle with axle stands or blocks.
8. Unscrew the wheel nuts.
9. Remove the wheel.
10.Fit the new wheel and tighten all wheel nuts in a diagonal se-
quence all the way to their end stops.
11.Tighten the wheel nuts to a torque of 180 Nm.
Filling the water reservoir
Filling nozzle
1
Symbol for the "Fill" lever position
2
Symbol for the "Closed" lever position
3
Switch lever
4
Filling level display
5
1. Open the cap on the filling nozzle.
2. Switch lever in the "Fill" position.
3. Fit a water supply hose onto the filling nozzle.
4. Fill the water reservoir.
Note
To prevent back suction, the water hose must not be inserted into
the water reservoir when filling.
5. Close off the water inlet.
6. Remove the water supply hose.
7. Close the cap on the filling nozzle.
8. Switch the switchover lever to the "Closed" position.
English 103