Program Priorities (Non-External Control) - Pentair WHISPERFLOXF VS Guía De Instalación Y Del Usuario

Programming Custom Schedules
6. Press "1". PROGRAM 1 duration will display. The
"Duration" parameter LED will begin to blink. See
Figure 11.
2 : 00
Figure 11
7. Use "+" and "-" to adjust the PROGRAM 1 duration in
hours and minutes.
Note: If operating the pump with external controls,
program PROGRAM 1 duration to 24 hours.
8. PROGRAM 1 has been successfully programmed.
Note: Pressing "1" will continue to cycle through these
parameters, but changes are immediately saved as
they are adjusted.
9. Press "2". The PROGRAM 2 LED and "Speed/FL%"
parameter LED will blink while editing.
10. Use "+" and "-" to adjust the PROGRAM 2 speed in
RPM, or percentage of flow if operating in Flow Mode.
11. Press "2". The PROGRAM 2 duration will display.
Note: PROGRAM 2 and 3 do not have a start time, as
they begin their duration after the previous PROGRAM
1 finishes.
12. Use "+" and "-" to adjust the PROGRAM 2 duration in
hours and minutes.
13. Repeat steps 9-12 to program PROGRAM 3 and QUICK
CLEAN.
Note: The PROGRAM 3 duration will be limited to the
remaining time in a 24 hour day. Any time in the 24
hour day not programmed into PROGRAM 1-3, the
pump will not run.
[ PROGRAM 1 + PROGRAM 2 + PROGRAM 3 < 24 Hours ]
14. Press Start/Stop and ensure the Start/Stop LED is
illuminated. The pump is now active and will run the
custom schedule.
Note: If the pump has been stopped via the Start/
Stop button, the pump will not run until the Start/
Stop button is pressed again. If the Start/Stop LED
is illuminated, the pump is active and will run the
programmed schedule.
Note: If you do not want the pump to run during a
specific time of the day, any of the PROGRAM can be
programmed to 0 RPM. This ensures the pump will
not run during the PROGRAM duration.
WHISPERFLO
(cont.)
XF XF
® ®
VS and MAX-E-PRO VS Commercial Variable Speed Pump Installation and User' s Guide
Program Priorities
(Non-External Control)
For schedule duration settings, PROGRAMs are
prioritized as follows: PROGRAM 1 -> PROGRAM
2 -> PROGRAM 3. PROGRAM 1 is the highest
priority, while PROGRAM 3 is the lowest.
The drive will not allow programming a schedule of
more than 24 hours. When the 24th hour of duration
is programmed, time will be taken from the lower
priority PROGRAM and added to the PROGRAM
being adjusted.
Example:
Starting Schedule (Before Adjustment)
PROGRAM 1 duration = 20 hours
PROGRAM 2 duration = 2 hours
PROGRAM 3 duration = 2 hours
If PROGRAM 1 is set to run for 23 hours,
PROGRAM 2 (lower priority) will automatically
adjust to a 1 hour duration and PROGRAM 3
(lowest priority) will adjust to a 0 hour duration.
End Schedule (After Adjustment)
PROGRAM 1 duration = 23 hours
PROGRAM 2 duration = 1 hour
PROGRAM 3 duration = 0 hours
9