Nice For-Max A XM0900003 Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

04. Press and hold the key ▲ until the motor performs
2 LONG motions (= position "0" memorised); then
2
release the key.
05. Press and hold the key ( ▼ or ▲ ) until the shutter
reaches the required position "1" then release the
key. Note - during movement, 1 brief interruption
1
indicates that only one limit position is memorised.
06. Press and hold the key ■ until the motor performs
1 VIBRATION; then release the key.
1
07. Press and hold the key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
08. Press and hold the key ▼ until the motor performs
2 LONG motions (= position "1" memorised); then
2
release the key.
Note – After this programming procedure, the key ▲ controls the Up manoeuvre
and the key ▼ controls the Down manoeuvre. Movement in these manoeuvres stops
shortly before programmed limits "0" and "1".
7.3 - Programming limit positions "0" and "1" SEMI-AUTOMATICALLY
Caution! – This programming mode is recommended for shutters that mount
"plugs" only.
01. Press and hold the key ( ▲ or ▼ ) until the shutter
0
is blocked by the plugs in the position "0" then
release the key. Note – during movement, 2 brief
interruptions indicate that no limit position is mem-
orised.
02. Press and hold the key ( ▼ or ▲ ) until the shutter
reaches the required position "1" (maximum clos-
ing) then release the key. Note – during movement,
1
1 brief interruption indicates that only one limit
position is memorised.
03. Press and hold the key ■ (for approx. 5 seconds),
(5")
until the motor performs 1 VIBRATION; then re -
1
lease the key.
04. Press and hold the key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
05. Press and hold the key ▼ until the motor performs
2 LONG motions (= positions "0" and "1" memo-
2
rised); then release the key.
Note – After this programming procedure, the key ▲ controls the Up manoeuvre
and the key ▼ controls the Down manoeuvre.
During Up movement the shutter is stopped in position "0" directly by the plugs.
7.4 - Programming limit position "1" and then limit position "0"
Caution! – This programming mode is recommended for shutters that mount
"plugs" only.
01. Press and hold the key (▼ or ▲ ) until the shutter
reaches the required position "1" then release the
key. Note – during movement, 2 brief interruptions
1
indicate that no limit position is memorised.
02. Press and hold the key ■ (for approx. 5 seconds),
until the motor performs 1 VIBRATION; then re -
1
lease the key.
03. Press and hold the key ■ again (for approx. 5 sec-
(5")
onds), until the motor performs 4 SHORT moti -
4
ons; then release the key.
04. Press and hold the key ▼ until the motor performs
2 LONG motions (= position "1" memorised); then
2
release the key.
05. At this point position "0" can be programmed ac -
cording to one of the following procedures:
English – 9