TRAPP TR 600 Manual De Instrucciones página 78

Blades must be sharpened with
proper machines to assure adequate
sharpening. Respect the angle
indicated in the figure below.
Fig. 5
Attention!
Do not replace just part of the
set of blades. Always replace the
whole set for rotor balance and
to prevent vibration.
Every time blades are removed
(disassembled/reassembled), check
adjustment and distance between blade
and counter-blade before turning on the
machine. To adjust the position of the
counter-blade:
Remove locking screws (4).
✔
Turn the rotor (1), bringing blades (2)
✔
near the counter-blade (3).
Adjust the position of counter-blade (3)
✔
with adjustment nut (5), allowing a
distance between blade and counter-
blade between 1.6 mm (0.063.") and
3.2 mm (0.126.").
Make sure the distance is the same for
✔
all blades.
Lock adjustment nuts (5) and tighten
✔
securing screw (4) with a torque
wrench, as shown in table "Torque
Specifications".
1
2
5
4
3
Check Belt Stretching
Belts are provided with an automatic
stretcher, spring, which needs to be
checked. To either increase or decrease
belt stretching, do as follows:
Stop the machine.
✔
Remove ignition key and disassemble
✔
cardan.
Remove screws from both transmission
✔
protections – upper and lower.
Remove both protections.
✔
76
ENGLISH
1.6 - 3.2