TRAPP TR 600 Manual De Instrucciones página 71

Before assembling the cardan, check
whether the number of revolutions and the
direction of the revolutions is the same of
that of the tractor. Carefully read cardan
and tractor instructions manual. Before
starting to work, check whether safety
protections on movable parts of the
machine, cardan and tractor are in place.
Pay special attention to safety protection
guards that cover the cardan.
Disconnect the two parts of the cardan
✔
(male/female).
Couple cardan to tractor discharge
✔
power.
Place the two parts of the cardan
✔
parallel to each other and mark the
cutting area, allowing 2.5 cm on each
end.
Cut excess on male and female ends.
✔
Connect the parts of cardan and couple
✔
it to tractor.
Secure protection retention chains. The
✔
ideal operation condition is obtained
with the chain placed radial to
transmission. Adjust the length of chains
to allow transmission to be articulated
under any working, transportation and
maneuvering condition. Make sure
chains do not entangle around the
transmission due to excessive length.
Before starting to work, make sure
✔
cardan transmission is properly secured
to the tractor and equipment. Check
whether securing screws are properly
tightened.
Cardan Assembly
clearance
69
ENGLISH
Note:
The pieces cut from the solid and
✔
tubular parts of the cardan shall have
the same length.
Allow at least 2.5 cm on each end of
✔
the cardan.
Do not use the chains to transport or
✔
support cardan transmission when
work is done. Use proper support.
When transporting transmission,
✔
keep it in horizontal position to
prevent parts from getting apart,
causing accidents or damaging
protection guard. Use transportation
means adequate to the weight of the
transmission.
2.5 cm