TRAPP TR 600 Manual De Instrucciones página 64

Trapp shredders, either single-phase or
✔
three-phase, are assembled with dual
voltage motors. They leave factory
without electric wiring so customers can
choose the one that best suits their
voltage needs.
For shredders sold without the motor,
✔
choose minimum power according to
technical data under "Technical
Characteristics."
For motors of power above 5 cv, the use
✔
of a delta-star switch is recommended.
The model suggested is ETW (WEG
Acionamentos) or of similar type.
As the on/off switch is distant from the
✔
shredder, install an emergency button in
the equipment in case immediate
switching off is necessary.
Attention!
Read all instructions herein before
operating the equipment. Always
observe and follow safety
instructions to prevent accidents
and/or injuries.
Residues Shredders models
TR 600/600E/600G and 600T are designed
to cut trimmed wood residues, branches,
chips, bushes, wood of diameter up to
Motor Installation
Shredder Usage
10 cm, package residues and other
wooden structures free from nails, wire or
other metals. Any other use poses a risk to
the integrity of the machine and to the
safety of the operator.
62
ENGLISH
Attention!
Before making any kind of
✔
connection, be sure the power
source is disconnected.
Make sure the power source
✔
where the shredder will be
installed is compatible with the
data on the motor plate.
Make the connections shown
✔
according to the voltage of the
power source.
Use insulating tape on the
✔
connections made to protect
them.
Make sure connections are well
✔
insulated.
Turn on power source and
✔
check the rotation of the motor.
Important:
Recently trimmed material must dry a
little before being shredded. It
increases the performance of the
shredder, providing better residue
composting.