Using The Data Card To Collect Data - ResMed VPAP Auto Guia Del Usuario

Note: To protect the data communications port, always ensure there is a
module attached to the back of the device.

Using the Data Card to Collect Data

Please refer to the illustrations in section H of the illustration sheet.
If your clinician needs to review your treatment, they will ask you to use the Data
Card to copy data from your VPAP Auto, and to return the card to them. The Data
Card will be provided in a convenient mailback envelope.
Data is copied onto the Data Card when it is inserted into the device. The original
data will remain stored on the device.
It takes up to 30 seconds to copy data onto the Data Card.
1 Insert the Data Card
Switch on the VPAP Auto and wait until you see the standby (RAMP or
•
SETTLING) screen.
Hold the Data Card with the arrow facing up, and insert it into the slot in the
•
Data Card module (H-1).
Push the card in smoothly until it stops moving (H-2) and messages start
•
appearing on the LCD.
2 Copy data onto the Data Card
Data copying starts automatically when the Data Card is inserted into the
•
Data Card module.
The "Card Inserted Please Wait" message is displayed on the VPAP Auto
•
LCD while data is being copied. Copying takes up to 30 seconds.
The "Copy Complete Remove Card" message is displayed on the LCD when
•
copying has finished.
Remove the Data Card from the Data Card module. No additional data is
•
copied onto the card once the "Copy Complete Remove Card" message is
displayed, even if the card is left in the device. To add additional data to the
Data Card, reinsert the card and repeat these steps.
3 Remove the Data Card
Grip the end of the Data Card and pull it out of the Data Card module (H-3).
4 Store the Data Card
Your Data Card should be stored in its mailback envelope when not in use.
5 Mail the Data Card to your clinician
When mailing the Data Card to your clinician:
1. Insert the Data Card into the pocket provided on the mailback envelope. Fold
up the mailback envelope.
2. Place the mailback envelope containing the Data Card in a postal envelope
and seal it.
3. Make sure that your clinician's name and address details are on the postal
envelope, and mail it back immediately.
Operating Instructions 19