Transmitting Data With The Data Card - ResMed S8 Elite Manual Clínico

338210r3 Eng.book Page 40 Monday, July 11, 2005 1:28 PM
I
NSERTING THE
To insert the Data Card, the patient needs to:
1. Ensure the
2. Insert the Data Card into the slot in the Data Card module (H-1). Continue
inserting the Data Card smoothly until it stops moving (H-2) and messages start
appearing on the LCD.
R
EMOVING THE
To remove the Data Card, the patient needs to:
1. Grip the end of the Data Card and pull it out (H-3).
2. Place the Data Card in the mailback envelope supplied.
T
RANSMITTING
C D
OPYING ATA ONTO A
If you want a patient to give you their data, you need to tell them how to copy data
onto their Data Card.
Instruct the patient to carry out the following steps to copy data onto a Data Card:
1. With the device in standby (RAMP) mode, insert the Data Card into the slot on
the Data Card module. Copying of data will start automatically.
2. The "Card Inserted Please Wait" message is displayed on the LCD while data is
copied to the Data Card. Copying takes up to 30 seconds.
3. The "Copy Complete Remove Card" message is displayed on the LCD.
4. Remove the Data Card from the device. If mailing the Data Card and mailback
envelope, put them in the bubble mailer to send to the clinician.
This information is also supplied in the patient's User's Manual.
U S
PDATING
You can create new treatment settings and transfer them to a Data Card via a ResMed
PC application. A patient can then use the Data Card to update the settings in their
. If you mail the Data Card to the patient, send it in the mailback envelope. If
S8 E
LITE
you need the Data Card sent back to you for verification, use a postal envelope to mail
the bubble mailer and its contents to the patient.
Instruct the patient to carry out the following steps to update settings on their
1. With the device in standby (RAMP) mode, insert the Data Card into the slot on
the Data Card module. Updating will start automatically.
2. The "Card Inserted Please Wait" message will appear on the LCD while updating
is in progress. Updating takes up to 30 seconds.
3. The "Settings Success Remove Card" message is displayed on the LCD, if the
settings were updated successfully.
Note: This message only appears once. If you re-insert the Data Card after you have
40
D C
ATA ARD
is switched on and displaying the standby (RAMP) screen.
S8 E
LITE
D C
ATA ARD
D D
ATA WITH THE ATA
D C
ATA ARD
F G
ETTINGS ON A LOW
C
ARD
ENERATOR
:
S8 E
LITE