Noise Hazard - Pentax VP6A Instrucciones De Uso

3. SAFETY

RISKS OF COMPONENT BREAKAGE DURING OPERATION
The manufacturer has used materials and design and constructive procedures suitable for the in-
tended use and to obtain a reliable and safe device but it is necessary to comply with the use the
assembly (motor / pump) has been designed for as well as with the inspections and maintenance
recommended in chapter 6 "MAINTENANCE".

RISKS OF ELECTROCUTION (only for pumps driven by electric motor)
Jets of water, steam, solvents or paints must be avoided near parts of the pump con-
taining electrical wires, and especially in close proximity to the electrical panel. Always
power off the electric pump before performing any maintenance operation.
WARNING!
Always earth the pump.

RISKS FROM UNSUITABLE LIGHTING (where applicable)
The operator and maintenance technician must ensure that all the pump areas are always lit
evenly and in compliance with the provisions of the regulations in force in the place of installation.


NOISE HAZARD

The pump and electric pump provided have the noise values given in chap. 2. In the event of applica-
tion of the pump with another motor, and in any case of installation in the pump room, the overall
noise level of the premises must be assessed in compliance with the laws in force in the country.
WARNING!
Pay attention to any abnormal noise emissions during operation.

RISKS FOR UNAUTHORISED USE
Every use of the pump other than that for which it has been designed may cause accidents, even
very severe, to the persons working in its close proximity. It is therefore extremely important to
strictly comply with all rules concerning use, maintenance and safety contained in this manual.
WARNING!
Do not intervene on the pump with under pressure liquid, but only with stop-
ped and power supply interrupted
14
Electrical panel