Filling Up Lubricant - Vogel KFG Serie Instrucciones Para El Manejo

2.5 Filling up lubricant

Cone-shaped grease nipple
Filling with lubricant shall be done through the
cone-shaped grease nipple, DIN 71412 -AM10x1,
by means of a common grease gun.
2
1 cone-shaped grease nipple
2 connection for installation
Fig. 7 Cone-shaped grease nipple
The positioning of the cone-shaped grease nipple
may be changed by screwing it in at position 2.
Alternatively, connection 2 may be used for fitting
a lubricant return system, if any.
Filler coupling (fluid grease)
For single parts, see Vogel Catalogue 1 -9430,
page 51. Remove grease nipple and replace it with
filler 995 - 000 -705. Mount the coupling sleeve
995 - 001 -500 on the filling pump.
995 - 000 -705
1
Remove protective cap 1 for filling operation
Fig. 8 Filling
Filling cylinder
For single parts, see Vogel Catalogue 1 -9430,
page 15. Remove screw plug M20 x 1.5 and replace
it with filler connector 169- 000 -170. For filling
operation, remove protective caps 1 at connector
and filling cylinder.
coupling sleeve
995 - 001- 500
M20 x 1,5
1
Fig. 9 Filling
Page 13
Contents Chapter
2
Operating Instructions KFG, KFGS
1
filling cylinder
169-000-171
filler connector
169-000-170