Motion Sensor - Lorex L23WD800 Serie Manual Del Usuario

Using the System Menu
• The PTZ Property window opens.
Figure 10.6 PTZ Setup menu.
6. In the PTZ Property window, configure the
following:
• AUTO FOCUS: Select ON/OFF
• AUTO IRIS: Select ON/OFF
• P/T SPEED, ZOOM SPEED, FOCUS SPEED,
IRIS SPEED: Select between 1 (low) ~ 10
(high)
7. Click OK .
• The PTZ Property window closes.
8. Click APPLY to save your settings or click
CANCEL to restore defaults.

MOTION SENSOR

Use the Motion Sensor menu to configure
motion detection settings for each camera.
To configure motion settings:
1. Click the MOTION SENSOR tab on the left.
• The Motion Sensor window opens.
Figure 10.7 Motion Sensor menu.
2. Under SENSITIVITY, double-click the value
to adjust the camera's sensitivity settings.
• The higher the number, the greater the
sensitivity.
54
3. Click the AREA SETUP button beside the
channel you wish to configure.
• The Motion Area Grid opens. Use the
Motion Area Grid to assign motion
detection to all or specific sectors of the
the grid.
Figure 10.8 Motion Grid.
4. Perform the following:
• Right-click anywhere on the screen to open
the quick menu and select SELECT ALL, or
DESELECT ALL, and then click SAVE &
EXIT.
By default, motion is applied to ALL
NOTE:
sectors of the grid for each camera.
OR
• Drag the mouse cursor to select the areas
of the screen that you do NOT want motion
detection.
White squares indicate motion is
NOTE:
applied. No squares indicate motion is not
applied. Yellow squares are highlighted by
the cursor.
5. Right-click to open the quick menu and
then click SAVE & EXIT.